Kipi Calculator REBAR CHART by Kipi Calculator
🌐 Español

Rebar for a 12×20 Slab

A 12×20 ft slab covers 240 ft². This chart uses the defaults of the rebar calculator: #4 bars (0.668 lb/ft) on a 12-in. on-center grid, both ways. Every bar stops 3 in. short of the edges for concrete cover, so each run is the slab size minus 6 in. Rebar is sold in 20-ft sticks — that is what the order count is figured on.

12×20 slab, #4 at 12 in.: 464 lin ft of steel · 24 sticks of 20 ft · about 321 lb (0.16 tons) — exact count, no waste added

Rebar for a 12×20 slab (#4, 12 in. on-center)

ItemCount
Bars running along the length20 × 11.5 ft
Bars running along the width12 × 19.5 ft
Total steel in the slab (exact)464 lin ft
20-ft sticks to buy (exact, 0% waste)24
Weight of the sticks you buyabout 321 lb (0.16 tons)
Sticks with 10% waste for cuts & laps — optional26 (about 347 lb)

How it is figured: bars along the length are spaced across the 20-ft width — the run across is 19.5 ft ÷ 1 ft spacing = 19.5, rounded down, plus 1 = 20 bars, each 11.5 ft long. The other way gives 12 bars of 19.5 ft. Total steel = 20 × 11.5 + 12 × 19.5 = 464 lin ft, and 464 ÷ 20-ft sticks rounds up to 24 sticks. Weight is figured on the full sticks you buy: 24 × 20 ft × 0.668 lb/ft.

The headline counts are exact — no waste is baked in. The calculator itself starts at 0% waste; its waste chips add your allowance for cuts and lap splices before the stick count. The 10% row above is the same figure the calculator gives with its 10% chip tapped. A different bar size or spacing changes everything — run those in the calculator.

Common questions

How many sticks of rebar do I need for a 12×20 slab?

24 sticks of #4 at 12 in. on-center — 464 lin ft of steel, about 321 lb. Bars stop 3 in. short of every edge, so each one runs 11.5 or 19.5 ft: 20 bars one way and 12 the other, and the footage divided by 20-ft sticks rounds up to 24.

What if my spacing is 18 inches instead of 12?

The steel drops fast. Same 12×20 slab in #4 at 18 in.: 317 lin ft — 16 sticks, about 214 lb, against 24 sticks at 12 in. Use the spacing your plans or code call for; the calculator figures 12, 16, 18, and 24 in.

Does the waste percentage cover lap splices?

Yes — that is what it is for. The grid count is exact bar length. The waste chips (they start at 0%) add your allowance for cuts and lap splices before the stick count: at 10%, this slab goes from 24 sticks to 26 — 510.4 lin ft, about 347 lb.