Rebar for a 16×20 Slab
A 16×20 ft slab covers 320 ft². This chart uses the defaults of the rebar calculator: #4 bars (0.668 lb/ft) on a 12-in. on-center grid, both ways. Every bar stops 3 in. short of the edges for concrete cover, so each run is the slab size minus 6 in. Rebar is sold in 20-ft sticks — that is what the order count is figured on.
Rebar for a 16×20 slab (#4, 12 in. on-center)
| Item | Count |
|---|---|
| Bars running along the length | 20 × 15.5 ft |
| Bars running along the width | 16 × 19.5 ft |
| Total steel in the slab (exact) | 622 lin ft |
| 20-ft sticks to buy (exact, 0% waste) | 32 |
| Weight of the sticks you buy | about 428 lb (0.21 tons) |
| Sticks with 10% waste for cuts & laps — optional | 35 (about 468 lb) |
How it is figured: bars along the length are spaced across the 20-ft width — the run across is 19.5 ft ÷ 1 ft spacing = 19.5, rounded down, plus 1 = 20 bars, each 15.5 ft long. The other way gives 16 bars of 19.5 ft. Total steel = 20 × 15.5 + 16 × 19.5 = 622 lin ft, and 622 ÷ 20-ft sticks rounds up to 32 sticks. Weight is figured on the full sticks you buy: 32 × 20 ft × 0.668 lb/ft.
The headline counts are exact — no waste is baked in. The calculator itself starts at 0% waste; its waste chips add your allowance for cuts and lap splices before the stick count. The 10% row above is the same figure the calculator gives with its 10% chip tapped. A different bar size or spacing changes everything — run those in the calculator.
Common questions
How many sticks of rebar do I need for a 16×20 slab?
32 sticks of #4 at 12 in. on-center — 622 lin ft of steel, about 428 lb. Bars stop 3 in. short of every edge, so each one runs 15.5 or 19.5 ft: 20 bars one way and 16 the other, and the footage divided by 20-ft sticks rounds up to 32.
What if my spacing is 18 inches instead of 12?
The steel drops fast. Same 16×20 slab in #4 at 18 in.: 431.5 lin ft — 22 sticks, about 294 lb, against 32 sticks at 12 in. Use the spacing your plans or code call for; the calculator figures 12, 16, 18, and 24 in.
Does the waste percentage cover lap splices?
Yes — that is what it is for. The grid count is exact bar length. The waste chips (they start at 0%) add your allowance for cuts and lap splices before the stick count: at 10%, this slab goes from 32 sticks to 35 — 684.2 lin ft, about 468 lb.