Kipi Calculator REBAR CHART by Kipi Calculator
🌐 Español

Rebar for a 20×24 Slab

A 20×24 ft slab covers 480 ft². This chart uses the defaults of the rebar calculator: #4 bars (0.668 lb/ft) on a 12-in. on-center grid, both ways. Every bar stops 3 in. short of the edges for concrete cover, so each run is the slab size minus 6 in. Rebar is sold in 20-ft sticks — that is what the order count is figured on.

20×24 slab, #4 at 12 in.: 938 lin ft of steel · 47 sticks of 20 ft · about 628 lb (0.31 tons) — exact count, no waste added

Rebar for a 20×24 slab (#4, 12 in. on-center)

ItemCount
Bars running along the length24 × 19.5 ft
Bars running along the width20 × 23.5 ft
Total steel in the slab (exact)938 lin ft
20-ft sticks to buy (exact, 0% waste)47
Weight of the sticks you buyabout 628 lb (0.31 tons)
Sticks with 10% waste for cuts & laps — optional52 (about 695 lb)

How it is figured: bars along the length are spaced across the 24-ft width — the run across is 23.5 ft ÷ 1 ft spacing = 23.5, rounded down, plus 1 = 24 bars, each 19.5 ft long. The other way gives 20 bars of 23.5 ft. Total steel = 24 × 19.5 + 20 × 23.5 = 938 lin ft, and 938 ÷ 20-ft sticks rounds up to 47 sticks. Weight is figured on the full sticks you buy: 47 × 20 ft × 0.668 lb/ft.

The headline counts are exact — no waste is baked in. The calculator itself starts at 0% waste; its waste chips add your allowance for cuts and lap splices before the stick count. The 10% row above is the same figure the calculator gives with its 10% chip tapped. A different bar size or spacing changes everything — run those in the calculator.

Common questions

How many sticks of rebar do I need for a 20×24 slab?

47 sticks of #4 at 12 in. on-center — 938 lin ft of steel, about 628 lb. Bars stop 3 in. short of every edge, so each one runs 19.5 or 23.5 ft: 24 bars one way and 20 the other, and the footage divided by 20-ft sticks rounds up to 47.

What if my spacing is 18 inches instead of 12?

The steel drops fast. Same 20×24 slab in #4 at 18 in.: 641 lin ft — 33 sticks, about 441 lb, against 47 sticks at 12 in. Use the spacing your plans or code call for; the calculator figures 12, 16, 18, and 24 in.

Does the waste percentage cover lap splices?

Yes — that is what it is for. The grid count is exact bar length. The waste chips (they start at 0%) add your allowance for cuts and lap splices before the stick count: at 10%, this slab goes from 47 sticks to 52 — 1031.8 lin ft, about 695 lb.