Rebar for a 20×30 Slab
A 20×30 ft slab covers 600 ft². This chart uses the defaults of the rebar calculator: #4 bars (0.668 lb/ft) on a 12-in. on-center grid, both ways. Every bar stops 3 in. short of the edges for concrete cover, so each run is the slab size minus 6 in. Rebar is sold in 20-ft sticks — that is what the order count is figured on.
Rebar for a 20×30 slab (#4, 12 in. on-center)
| Item | Count |
|---|---|
| Bars running along the length | 30 × 19.5 ft |
| Bars running along the width | 20 × 29.5 ft |
| Total steel in the slab (exact) | 1175 lin ft |
| 20-ft sticks to buy (exact, 0% waste) | 59 |
| Weight of the sticks you buy | about 788 lb (0.39 tons) |
| Sticks with 10% waste for cuts & laps — optional | 65 (about 868 lb) |
How it is figured: bars along the length are spaced across the 30-ft width — the run across is 29.5 ft ÷ 1 ft spacing = 29.5, rounded down, plus 1 = 30 bars, each 19.5 ft long. The other way gives 20 bars of 29.5 ft. Total steel = 30 × 19.5 + 20 × 29.5 = 1175 lin ft, and 1175 ÷ 20-ft sticks rounds up to 59 sticks. Weight is figured on the full sticks you buy: 59 × 20 ft × 0.668 lb/ft.
The headline counts are exact — no waste is baked in. The calculator itself starts at 0% waste; its waste chips add your allowance for cuts and lap splices before the stick count. The 10% row above is the same figure the calculator gives with its 10% chip tapped. A different bar size or spacing changes everything — run those in the calculator.
Common questions
How many sticks of rebar do I need for a 20×30 slab?
59 sticks of #4 at 12 in. on-center — 1175 lin ft of steel, about 788 lb. Bars stop 3 in. short of every edge, so each one runs 19.5 or 29.5 ft: 30 bars one way and 20 the other, and the footage divided by 20-ft sticks rounds up to 59.
What if my spacing is 18 inches instead of 12?
The steel drops fast. Same 20×30 slab in #4 at 18 in.: 803 lin ft — 41 sticks, about 548 lb, against 59 sticks at 12 in. Use the spacing your plans or code call for; the calculator figures 12, 16, 18, and 24 in.
Does the waste percentage cover lap splices?
Yes — that is what it is for. The grid count is exact bar length. The waste chips (they start at 0%) add your allowance for cuts and lap splices before the stick count: at 10%, this slab goes from 59 sticks to 65 — 1292.5 lin ft, about 868 lb.