Free EPDM Rubber Roof Calculator
Enter the roof size — get membrane, sheets, adhesive, seam tape and sealant for a flat rubber roof.
0 = no parapet; the sheet gets a 3 in edge overhang instead.
Waste allowance Starts at 0% — tap to add spare sheets for cuts & future patches.
Membrane you need
– sq ft
⚠️ No mastic on the rubber
Regular roof mastic and plastic roof cement are petroleum-based and eat EPDM — the rubber swells, softens and leaks. Seams are primer + seam tape; exposed edges get EPDM lap sealant. Water cut-off mastic is the only rubber-safe mastic, and it goes behind the membrane under bars and clamps.
💡 Pro field tips
- Unroll the sheet and let it relax at least 30 minutes before gluing — glue down the factory folds and they never come out.
- Warm, dry day only. The adhesives don't set right cold or wet.
- Lay it relaxed, never stretched tight — EPDM shrinks a little over the years.
- Roll every seam hard with a steel seam roller. Seams are where rubber roofs leak or don't.
- A wrinkle crossing a seam (a fishmouth) gets cut flat and patched, never glued down as-is.
- Keep anything petroleum-based — tar, oils, asphalt caulk — off the membrane.
Copied to clipboard ✓
Most Asked Questions
How much EPDM membrane do I need for a 40 x 25 ft roof?
1,215 sq ft of membrane: 3 sheets of 10 ft x 40.5 ft. The sheets are figured at 9.75 ft of coverage each (10 ft minus the 3-inch seam overlap), and each sheet runs 3 inches long at both ends, so the membrane total is bigger than the 1,000 sq ft roof.
What does a parapet change?
It makes every sheet longer. The sheet length grows by twice the parapet height: a 12-inch parapet turns 40.5 ft sheets into 42 ft sheets and the membrane total rises to 1,260 sq ft on the same 40 x 25 roof.
How much bonding adhesive do I need?
One gallon per 60 sq ft of finished roof. On a 1,000 sq ft roof that is 17 gallons, so 4 of the 5-gallon pails. The 60 sq ft rate already counts adhesive on both surfaces.
How much seam tape and lap sealant?
Seam tape comes in 100 ft rolls; lap sealant covers about 22 ft per tube. The 40 x 25 example has 80 ft of seams (1 roll of tape) and 210 ft of seams plus perimeter to seal, which takes 10 tubes.
Can I use regular roofing mastic on EPDM?
No — it damages the rubber. Only use sealants and tapes the membrane manufacturer rates for EPDM, or the sheet can swell, soften and fail at the seams.
What does the waste percentage change on this calculator?
Only the sheet count. At +10%, a 3-sheet roof orders 4 sheets so you hold a spare for cuts and future patches; seams, adhesive and tape are always figured on the installed roof. It starts at 0% — nothing is added until you tap a percentage.
Estimates for planning only — confirm final quantities with your supplier and follow local building code.